Deutsch 
English 
ballast with parameter adjustment and remote control for two 4-pin UV-lamps, lamp power up to 600W
lamp power: up to 600 W
lamp current: up to 6,0 A
Features
- preheat start ballasts for optimal lamp opertaion with adjustable operation parameters
- double device - powers two lamps, independent lamp operation even if one lamp is defective oder disconnected
- adjustable preheats and operation parameter settings for use in different environmental conditions
- controllable via PLC or ZED ZCON control units, allows dimming, using remote mode the status relay wiring can be omitted
- lamp and ballast status indication
- green, red and yelloe LEDs
- ModBus/ZCON status request
- optional: potential free relay contacts - up to 30 m lamp cable length possible
- local operation and digital remote conrol
- lamp operation control via RS485 using ModBus or ZCON protocol, optional:
ethernet interface
- dimming using analog 4...20mA/0...10V interface - metal housing, designed for optimal thermal flow
- push-in contacts for quick installation
- enhanced protection
- power range control
- undervoltage protection
- overtemperature protection - high efficiency
- active power factor correction (PFC)
low THD according to EN 61000
Technical Specification
| supply voltage: | 230 V AC ± 10% / 45-65 Hz (115 V AC types on request) |
|---|---|
| efficiency: | >90% |
| operation temperature: | max. 50°C (122°F) at TC-point (ballasts are overtemperature protected ) |
| ambient temperature: | 0 - 40°C (32 - 104°F) |
| IP code: | IP20 |
| dimensions (LxWxD): | 269 x 317 x 83 mm (10,57 x 12,46 x 3,27 inch) |
UV lamp types
- GPHHA1554T10L
- NNI 400/147 XL
- NNI 600/147 XL *
* special application
(ballasts for other UV lamp types available on request)
ZED control units
- ZCONmini
- ZCONdin
- ZCONnano
- ZCONsub
