Products

Specify Selection

  • Hide Filters
  • Show Filters

Specify Selection

  • Hide Filters
  • Show Filters

ballast with parameter adjustment and remote control for two 4-pin UV-lamps, lamp power up to 600W

lamp power: up to 600 W

lamp current: up to 6,0 A

Features

  • preheat start ballasts for optimal lamp opertaion with adjustable operation parameters
  • double device - powers two lamps, independent lamp operation even if one lamp is defective oder disconnected
  • adjustable preheats and operation parameter settings for use in different environmental conditions
  • controllable via PLC or ZED ZCON control units, allows dimming, using remote mode the status relay wiring can be omitted
  • lamp and ballast status indication
    - green, red and yelloe LEDs
    - ModBus/ZCON status request
    - optional: potential free relay contacts
  • up to 30 m lamp cable length possible
  • local operation and digital remote conrol
  • lamp operation control via RS485 using ModBus or ZCON protocol, optional:
    ethernet interface
    - dimming using analog 4...20mA/0...10V interface
  • metal housing, designed for optimal thermal flow
  • push-in contacts for quick installation
  • enhanced protection
    - power range control
    - undervoltage protection
    - overtemperature protection
  • high efficiency
  • active power factor correction (PFC)
    low THD according to EN 61000

Technical Specification

supply voltage: 230 V AC ± 10% / 45-65 Hz (115 V AC types on request)
efficiency: >90%
operation temperature: max. 50°C (122°F) at TC-point (ballasts are overtemperature protected )
ambient temperature: 0 - 40°C (32 - 104°F)
IP code: IP20
dimensions (LxWxD): 269 ​​x 317 x 83 mm (10,57 x 12,46 x 3,27 inch)

UV lamp types

  • GPHHA1554T10L
  • NNI 400/147 XL
  • NNI 600/147 XL *

* special application

(ballasts for other UV lamp types available on request)

ZED control units

  • ZCONmini
  • ZCONdin
  • ZCONnano
  • ZCONsub


Products