Deutsch 
English 
ballast with parameter adjustment and remote control for 4-pin UV-lamps, lamp power up to 600W
lamp power: up to 600 W
lamp current: up to 6,0 A
Features
- preheat start ballasts for optimal lamp operation with adjustable operation parameters
- single device - powers one lamp
- adjustable preheat and operation parameter settings for use in different environmental conditions
- controllable via PLC or ZED ZCON control units, allows dimming, using remote mode the status relay wiring can be omitted
- lamp and ballast status indication
- green, red and yellow LEDs
- potential free relay contacts
- ModBus/ZCON status request - up to 30 m cable length possible, constant lamp and preheat current even with long cables
- local operation and digital remote control
- lamp operation control via RS485 using ModBus or ZCON protocol
- metal housing, designed for optimal thermal flow
- push-in contacts for quick installation
- enhanced protection
- power range control
- undervoltage protection
- overtemperture protection - high efficiency
- active power factor correction (PFC)
low THD according to EN 61000
Technical Specification
| supply voltage: | 230 V AC ± 10% / 45-65 Hz |
|---|---|
| efficiency: | >90% |
| operation temperature: | max. 50°C (122°F) at TC-point (ballasts are overtemperature protected) |
| ambient temperature: | 0 - 40°C (32 - 104°F) |
| IP code: | IP20 |
| dimensions (LxWxD): | 248 x 150 x 59 mm (9.76 x 5,89 x 2.32 inch) |
UV lamp types
- GPHHA1554T10L
- NNI 400/147 XL
- NNI 600/147 XL *
* special application
(ballasts for other UV lamp types available on request)
ZED Control Units
- ZCONmini
- ZCONdin
- ZCONnano
- ZCONsub
