ballast with parameter adjustment and remote control for 4-pin UV-lamps, lamp power up to 325W
lamp power: up to 325 W
lamp current: up to 2,2 A
Features
- preheat start ballasts for optimal lamp operation with adjustable operation parameters
- fourfold device - powers four lamps, independent lamp operation even if one lamp is defective or disconnected
- adjustable preheat and operation parameter settings for use in different environmental conditions
- controllable via PLC or ZED ZCON control units, allows dimming, using remote mode the status relay wiring can be omitted
- lamp and ballast status indication - green, red and yellow LEDs - ModBus/ZCON status request - optional: potential free relay contacts
- up to 30 m lamp cable length possible
- local operation and digital remote control
- lamp operation control via RS485 using ModBus or ZCON protocol, optional: - ethernet interface - dimming using analog 4...20mA/0...10V interface
- rack mounting ballasts - less space for more ballasts - front acceccible push-in contacts for quick installation
- enhanced protection - power range control - undervoltage protection - overtemperature protection
- high efficiency
- active power factor correction (PFC) low THD according to EN 61000
Technical Specification
| supply voltage: | 230 V AC ± 10% / 45-65 Hz (115 V AC types on request) |
|---|---|
| efficiency: | > 90% |
| operation temperature: | max. 50 ° C (122 ° F) at TC-point (ballasts are overtemperature protected) |
| ambient temperature: | 0 - 40 ° C (32-104 ° F) |
| IP code: | IP00 |
| dimensions (LxWxD): | 270 x 250 x 70 mm (10,61 x 9,82 x 2,75 inch) |
UV lamp types
- GIA1554T5LCA
- GIA1554T6LCA
- GIA1554T6LCA / 320
- GPHA1554T5L
- TUV 325W XPT
- GPHHA1554T6L
- GPHHA1000T6L
- NNI 300/147 XL
- NIQ 290/155 XL
- NIQ 300/147 XL
(ballasts for other UV lamp types available on request)
ZED Control Units
- ZCONmini
- ZCONdin
- ZCONnano
- ZCONsub